アイコンの内容は詳細ページよりダウンロード頂けます
SDR−120−12

12V/10A、120W シングル出力産業用DINレール電源、PFC機能付き
     
SDR-120-12 12V/10A、120W シングル出力産業用DINレール電源、PFC機能付き
SDR-120-12

・高効率91%、低消費電力
・150%ピーク負荷能力
・アクティブPFC機能内蔵、PF>0.93
・保護:ショート/過電圧/過負荷/過温度
・冷却はフリーエアー
・DINレール取り付け可
・UL508(産業制御装置)は承認
・EN61000-6-2(EN50082-2)の産業用イミニティーレベル
・100%全負荷バーンインテスト
Output
DC VOLTAGE 12 V
RATED CURRENT 10 A
CURRENT RANGE 0 ~ 10 A
RATED POWER 120 W
PEAK CURRENT 15 A
PEAK POWER                  Note.6 180 W (3 sec.)
RIPPLE & NOISE (max.)     Note.2 100mVp-p
VOLTAGE ADJ. RANGE 12 ~ 14V
VOLTAGE TOLERANCE      Note.3 ±1.0%
LINE REGULATION ±0.5%
LOAD REGULATION ±1.0%
SETUP, RISE TIME 1500ms, 60ms/230 VAC
3000ms, 60ms/115 VAC at full load
HOLD UP TIME (Typ.) 20ms/230 VAC
20ms/115 VAC at full load
Input
VOLTAGE RANGE            Note.7 88 ~ 264 VAC
124 ~ 370 VDC
FREQUENCY RANGE 47 ~ 63Hz
POWER FACTOR (Typ.) 0.93/230 VAC
0.96/115 VAC at full load
EFFICIENCY (TyINPUT p.) 89%
AC CURRENT (Typ.) 1.4 A/115 VAC
0.7 A/230 VAC
INRUSH CURRENT (Typ.) 35 A/115 VAC
70 A/230 VAC
LEAKAGE CURRENT <1 mA/240 VAC
PROTECTION
OVERLOAD Normally works within 110 ~ 150% rated output power for more than 3 seconds and then shut down o/p voltage
>150% rated power, constant current limiting with auto-recovery within 3 seconds and shut down o/p voltage after 3 seconds
OVER VOLTAGE 14 ~ 17V
Protection type : Shut down o/p voltage, re-power on to recover
OVER TEMPERATURE 95°C ±5°C (TSW : detect on heatsink of power switch)
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
FUNCTION
DC OK REALY CONTACT
RATINGS (max.)
60 Vdc/0.3A, 30Vdc/1A, 30Vac/0.5A resistive load
ENVIRONMENT
WORKING TEMP. -25 ~ +70°C (Refer to "Derating Curve")
WORKING HUMIDITY 20 ~ 95% RH non-condensing
STORAGE TEMP., HUMIDITY -40 ~ +85°C , 10 ~ 95% RH
TEMP. COEFFICIENT ±0.03%/°C (0 ~ 50°C)
VIBRATION Component:10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes; Mounting: Compliance to IEC60068-2-6
SAFETY & EMC (Note 4)
SAFETY STANDARDS UL508, TUV EN60950-1 approved
WITHSTAND VOLTAGE I/P-O/P:3KVAC     I/P-FG:1.5KVAC     O/P-FG:0.5KVAC     O/P-DC OK:0.5KVAC
ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:>100M Ohms / 500VDC / 25°C / 70% RH
EMC EMISSION Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3
EMC IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN61000-6-2 (EN50082-2), EN61204-3, heavy industry level, criteria A, SEMI F47, GL approved
OTHERS
MTBF 289.9Khrs min. MIL-HDBK-217F (25 °C)
DIMENSION 40*125.2*113.5mm (W*H*D)
PACKING 0.67Kg; 20pcs/14.4Kg/1.16CUFT
NOTE
  1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.
  2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
  3. Tolerance : includes set up tolerance, line regulation and load regulation.
  4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.
  5. Installation clearances : 40mm on top, 20mm on the bottom, 5mm on the left and right side are recommended when loaded permanently with full power. In case the adjacent device is a heat source, 15mm clearance is recommended.
  6. 3 seconds max., please refer to peak loading curves.
  7. Derating may be needed under low input voltage. Please check the derating curve for more details.
■ Mechanical Specification
■ Block Diagram
■ DC OK Relay Contact
■ Peak Loading
■ Derating Curve ■ Output derating VS input voltage
SDR-120-12 12V/10A、120W シングル出力産業用DINレール電源、PFC機能付き